Adapting the boiler to the heating installation
Installation and maintenance instructions ecoTEC plus 0020116700_01
49
11
11
Adapting the boiler to the heating
installation
The installation assistant is started when the boiler is
switched on for the first time (
¬ section 10.2
).
If you have already filled the heating installation and termi-
nated the installation assistant, but wish to set the most
important system parameters again, you can also call up
the "Appliance configuration" menu point.
Menu ¬ Installer level ¬ Appliance configuration
All of the settings for more complex systems can be found
in the diagnosis menu.
Menu ¬ Installer level ¬ Diagnosis menu
11.1
Diagnosis codes – Overview
Menu ¬ Installer level ¬ Diagnosis menu
With the use of the parameters that are marked as adjusta-
ble in
¬ table 11.1
, you can adapt the boiler to the heating
installation and the needs of the customer:
i
You can enter your settings in the last column
after setting the system-specific parameters.
>
Press the minus button
or the plus button
to switch between the displayed diagnosis
codes.
With modifiable parameters:
>
Press the right selector button
("Selection")
to select the parameter to make a change.
>
Press the minus button
or the plus button
to change the current setting.
>
Press the right selector button
("Ok") to con-
firm the change.
The change is saved.
Summary of Contents for ecoTEC plus SERIES
Page 89: ......
Page 90: ......
Page 91: ......
Page 92: ...0020116700_01 GBIE 012012 Subject to change Manufacturer Supplier...
