4 Product overview
8
Installation instructions aroTHERM 0020147164_09
3
Ribbed pipe heat ex-
changer
4
Temperature sensor
of the ribbed pipe heat
exchanger
5
4-way valve
6
Return heating circuit
temperature sensor
7
High-efficiency pump
with flow rate sensor
8
Purging valve
9
Flow heating circuit
temperature sensor
10
Drain valve
11
Plate heat exchanger
12
Temperature sensor
after the plate heat
exchanger
13
Service valve for the
high-pressure range of
the refrigerant circuit
14
High-pressure pressure
switch in the refrigerant
circuit
15
High-pressure sensor in
the refrigerant circuit
16
Compressor outlet
temperature sensor
17
Rotary piston com-
pressor
18
Filter
19
Liquid separator
20
Electronic expansion
valve
21
Compressor inlet tem-
perature sensor
22
Service valve for the
low-pressure range of
the refrigerant circuit
23
Flow rate limiter (cool-
ing mode) on the VWL
85/2 A 230 V only
24
Filter
25
Gas buffer
A
Heating return
B
Heating flow
4
Product overview
4.1
Type designation and serial number
1
1
The type designation and serial number are on the data plate
(1)
.
4.2
Information on the data plate
Information on the data
plate
Meaning
Serial no.
Unique unit identification number
P max
Maximum rated power
I
Max. operating current
I max
Maximum in-rush current
R410A
Refrigerant type and fill quantity
GWP 2088
Global Warming Potential of the
refrigerant
Information on the data
plate
Meaning
PS
R
_LP
PS
R
_HP
Min. and max. operating pres-
sure in the refrigerant circuit
PS
H
min
PS
H
max
Minimum and maximum operat-
ing pressure in the heating circuit
COP (Ax/Wxx)
Output figure (coefficient of
performance) at an air inlet
temperature of xx °C and a
heating flow temperature of
xx °C
(Ax/Wxx)
Heating output at an air inlet
temperature of xx °C and a
heating flow temperature of
xx °C
Volt
Compressor, pump and control
mains voltage
Hz
Mains frequency
IP
Protection class
Compressor
Fan
Pump
Control
4.3
CE marking
The CE marking shows that the products comply with the
basic requirements of the applicable directives as stated on
the declaration of conformity.
The declaration of conformity can be viewed at the manufac-
turer's site.
4.4
Local regulations
Benchmark places responsibilities on both manufacturers
and installers. The purpose is to ensure that customers are
provided with the correct equipment for their needs, that it is
installed, commissioned and serviced in accordance with the
manufacturer’s instructions by a competent person approved
at the time by the Health and Safety Executive and that it
meets the requirements of the appropriate Building Regu-
lations. The Benchmark Checklist can be used to demon-
strate compliance with Building Regulations and should be
provided to the customer for future reference.
Installers are required to carry out installation, commission-
ing and servicing work in accordance with the Benchmark
Code of Practice which is available from the Heating and
Hotwater Industry Council who manage and promote the
Scheme.
