background image

  

6

  Dimensions

  

3

  

Operating Specifications

 Operation 

Hot Water Supply Temperature:
Maximum: 85° C
Minimum: 10° C higher than the maximum required mixed temperature (advise 65° C)

Operating Pressure: 
Minimum operating pressure 1 bar
Maximum operating pressure 5 bar

1152mm

110mm

64mm

577mm

110mm

254mm

254mm

To divert the water from the handset to 
the riser, turn anti-clockwise. 
To divert the water from the riser to the 
handset, turn clockwise. 

  Maintenance

To  remove any build up of limestone on 
the handset and shower head, just rub 
your fingers lightly over the nozzles.

1090mm

Summary of Contents for wg-rrk/div-148

Page 1: ...red means is therefore recommended Under this guarantee which is non transferable Vado will at its option repair or replace free of charge any product or replacement part found to be defective The guarantee does not extend to any consequential loss or damage After repair or replacement the relevant guarantee period will be calculated from the original date of purchase The relevant guarantee period...

Page 2: ...S6700 Regulations We strongly recommend that you use a qualified and registered plumber Installer must comply with current regulations Please note if installing in an enclosed environment access should be left for servicing and maintenance No costs relating to inadequate access can be accepted Care of the mixer Our products are finished to the highest standard and due care needs to be taken to ens...

Page 3: ...essure Minimum operating pressure 1 bar Maximum operating pressure 5 bar 1152mm 110mm 64mm 577mm 110mm 254mm 254mm To divert the water from the handset to the riser turn anti clockwise To divert the water from the riser to the handset turn clockwise Maintenance To remove any build up of limestone on the handset and shower head just rub your fingers lightly over the nozzles 1090mm ...

Page 4: ...m drill bit for the wall plug drill the wall at the top marked position and fix the mount boss in position using the supplied wall plug and screw Prepare the wall for the diverter using a flush connector This should be connected to the shower valve Using PTFE tape screw the adapter into the connector and tighten Take the riser rail assembly and push the mount onto the boss and the diverter onto th...

Reviews: