background image

2

  

3

Important information .............................................. 3
General installation ...................................................3
Operating Specifications ...........................................3
Capsule - zones .........................................................4
Dimensions ................................................................5
Installation  ................................................................6
Installation - waste ....................................................9
Cleaning instructions ..............................................10
Maintenance ............................................................10
Guarantee ................................................................11

Contents

Please read these instructions carefully before starting installation and keep for  

future reference.
Remove all packaging and check the product for missing parts or damage before 

starting installation.
Any alterations made to this product and fittings may infringe water regulations and 

will invalidate the guarantee.
The installation must comply with all Local/National Water Supply Authority 

Regulations/Byelaws and Building and Plumbing Regulations.  

To be installed in accordance with BS EN806.
We strongly recommend that you use a qualified and registered plumber.

General installation

Operating Specifications

Important - please read

Operating Pressure

Minimum operating pressure dependent on shower and handset used.

When installed, the fitting must comply with the requirements of the Water Supply 

(Water Fittings) Regulations 1999 and Scottish Byelaws 2004. 

For further information, contact the Water Regulations department of your local water 

supplier (see the WRAS website www.wras.co.uk for details) or the Water Regulations 
Advisory Scheme by email (info

@

wras.co.uk) or telephone: 01495848454.

To comply with these regulations, it is highly recommended to install the product where 

it is not possible for the handset to reach a fluid category 5 appliance such as a WC 

or bidet. See illustration diagram on page 4 which highlights this requirement. If the 

handset can reach a WC or bidet, both hot and cold water supplied to this fitting must 

come from a storage cistern.
Before making any inlet pipe connections, all supply pipes MUST be thoroughly flushed 

to remove debris. Failure to do so could result in damage or low flow from the mixer 

unit. Water Supply (Water Fittings) Regulations 1999 Schedule 2 Section 13.
The fitting of isolating valves to the inlet feeds is advised for ease of maintenance.
Please take great care when installing this mixer not to damage its surface.
Please note if installing in an enclosed environment, access should be left for servicing 

and maintenance. No costs relating to inadequate access can be accepted.

Reviews: