6
3
Installation
Before installing your new mixer,
supply.
NOT-200 & GEO-200 -
Position the base onto the
bottom of the mixer body make sure
that the pins locate into the base.
Ensure the O-ring is in place on the
underside of the base.
ORI-200 -
Position the base ring onto
the bottom of the mixer body.
Ensure the O-ring is in place on the
underside of the base.
Screw the threaded rod into the back
hole in the base of the mixer body.
Position the mixer on the basin.
mixer body, hand tighten only, but
do not over tighten.
the left.
the washer onto the threaded rod,
the rubber side should be on top.
Screw on the nut and tighten to
clamp the mixer to the basin.
CAUTION:
Do not over tighten as this
may damage the parts and/or the
basin.
Connect the water supply to the
inlet pipes. The hot water should be
connected to the left hand pipe.
Base
Locating pins
(NOT-200 only)
Washer
Threaded
rod
Nut
Flexible pipes
Control
handle
Aerator
Installers/users notes
