8
9
Installation
Remove the backing paper from the seal located on the back of the plate. Slide the
plate over the valve, push onto the wall until it makes contact.
Carefully slide the control handle onto the valve and secure in position with the
grub screw located within the handle using the hexagonal key supplied, replace the
screw cover.
Note:
If the valve is sited within in a wet environment, it is recommended that once
the valve is commissioned the plate is sealed with a thin bead of sealant around
three sides to provide a water-tight seal between the plate and the wall material,
leaving the bottom edge free to allow for maintenance purposes.
Valve
Backing paper
Plate
Grub screw
Handle
Screw cover
Operation
Moving the mixer lever from right to left
will increase the water temperature.
Moving the mixer lever from left to right
will decrease the water temperature.
Pulling the mixer lever outwards will
increase the flow of water.
Lever in the off position.
