Vaderstad Rexius Twin Series, Instructions Manual

Page: 11 / 28

RST 330-400
14.04.2014
ver.2
11
1.6 Moving the machine when not hitched to a tractor
NOTE! If the machine must be moved when not hitched to a tractor,it must be transported on a ma-
chine trailer or lorry flatbed!
The machine must be rolled onto and off the transport vehicle using a tractor. Lifting with a crane
is prohibited!
1 Raise the machine to the full lifting height.
2 Reverse the machine lengthwise onto the trailer or flatbed. If using a flatbed, a ramp, loading
pier or similar will be required. Take great care. Check that no machine parts are damaged
during loading.
3 Lower the compaction roller to the ground. Adjust the wheel carrier so that the transport wheels
also rest on the ground.
4 Adjust and secure the parking stay so that the machine rests on the parking stay, compaction
roller and transport wheels.
5 Secure the machine's transport wheels and compaction roller to prevent rolling using chocks
or similar.
6 Unhitch the tractor from the machine.
7 Secure the machine using suitable lashing equipment in accordance with applicable rules. The
lashing equipment must be attached to the machine at the locations indicated by the decals; see
“Figure 1.9”.
!
For information on the machine's dimensions and weight, see ” 5.2 Technical data” on page
26 !
!
Always make sure that you comply with applicable national regulations concerning transport
dimensions, requirements for escort vehicles or similar!
Figure 1.9