ZoomSHOT 20 for AV Bridge MATRIX PRO
ZoomSHOT 20 System for AV Bridge MARTIX PRO, Document Number 342-0962 Rev A
Page 8 of 18
Step By Step Installation Instructions:
Step 1:
After determining the optimum location of the camera, route, mark and
test the two (2) Cat-5 cables from the camera to the MATRIX PRO. The two Cat-
5e cables should feed-through the hole located on the rear flange of the Thin
Profile Wall Mount. If the bracket is to be mounted on a 1-gang wall box, use the
screws supplied with the wall box cover plate to attach the Thin Profile Wall Mount.
If mounting to the drywall with wall anchors, use two (2) quality wall anchors
(included). The mounting holes are slotted and are 90° opposing to provide easy
leveling. Level the mount and tighten the mounting screws.
Step 2:
Using the HD VIDEO SELECT rotary switch and CAMERA SETTINGS dip switches on the back of the camera, set
up the camera’s output resolution and functional preferences. There are tables on previous pages that identify the
choices…
maybe keep these tables handy for future use…or you can easily look them up on the Vaddio website
(vaddio.com) when needed.
On the back of the ZoomSHOT 20
Set the desired HD Resolution with the rotary selection switch.
Set the IR frequency of the camera (if it is to respond to the IR remote control).
Set the image orientation (normal or flipped).
Step: 3:
Follow the sample wiring diagram for connecting the Cat-5 cables to the ZoomSHOT 20 and MATRIX
PRO (yep, on the previous page, but read and understand the rest of these instructions, especially the next note).
NOTE:
Check all Cat-5e cables for continuity in advance of the final connection. Label the
Cat-5e cables. Plugging the EZ-POWER VIDEO cable into the wrong RJ-45 may cause
damage to the camera system and void the warranty. For premise cabling, please use real
RJ-45 connectors and real crimpers. Please don’t use the pull through or EZ-type RJ-45s.
System Wiring
Follow the sample wiring diagram (page 11) for connecting the Cat-5e cables to the camera and Quick-Connect
Interface. Additional diagrams are available on the Vaddio website.
Connect the ZoomSHOT camera side as follows:
Connect the EZ-POWER VIDEO Cat-5 to the EZ-POWER VIDEO RJ-45 connector on the ZoomSHOT.
Connect the RS-232 control Cat-5 to the RS-232 RJ-45 on the ZoomSHOT.
Connect the MATRIX PRO side as follows
:
Connect the RS-232 Cat-5 cable to the RS-232 connector on the MATRIX PRO.
Connect the EZ-POWER VIDEO Cat-5e to the EZ-POWER VIDEO RJ-45 connector on the MATRIX PRO.
Step 4:
Use the provided ¼”-20 screws to secure the camera to the mount. To dress the cabling, push the extra
cable back into the wall opening.
Step 5:
Connect the power supply provided with the MATRIX PRO and Plug the AC side into an AC outlet (thanks
Captain Obvious). Power will travel down the EZ-POWER VIDEO Cat. 5 cable to the camera. The camera will
boot up and in a few seconds, the MATRIX PRO will auto-identify the camera and load the specific control protocols
for the camera, HSDS (differential) video will travel back down the Cat-5 cable and be ready to accept control
information from MATRIX PRO.
