ZoomSHOT 20 QSR Camera System
ZoomSHOT 20 QSR System Document Number 342-0968 Rev A
Page 7 of 20
Q
UICK
-C
ONNECT
SR
I
NTERFACE
Image: Rear Panel with Feature Call-outs
1) Power Input:
A 5.5mm OD x 2.5mm ID coaxial connector for the provided 24 VDC, 2.08 Amp power supply.
2) EZ-POWER VIDEO Port (Color Coded Orange):
A single Cat-5 connection between the EZCAMERA POWER & HD VIDEO RJ-45 connector and the camera’s EZ
Power HD Video Port on the HD-20 camera extends power and video. Power is fed to the camera and HSDS
video is returned from the camera on the same Cat-5.
3) HD Video Output
:
DE-15 connector outputs the YPbPr analog component HD video, which was extended from the camera over Cat-
5 cable. SD video resolutions (Y/C and CVBS formats) are not supported by the Quick-Connect SR Interface,
however analog component SD video is supported.
4) IR Output:
With the IR pass-thru turned ON (see camera dip switch settings), IR from third-party IR remote controls can be
sent through the ZoomSHOT camera to third-party equipment, such as hardware videoconferencing codecs. IR
can be used as either modulated (through the air) or non-modulated (wired) signals.
5) RS-232 INPUT (Color Coded Grey) & RS-232 OUT TO CAMERA Jacks:
These RJ-45 connectors allow an external controller (beware of upcoming shameless plug) like the
ProductionVIEW™ Precision Camera Controller to route through the Quick-Connect SR for ease of cabling.
①
②
④
⑤
③
