Page 2 of 7
•
Telnet commands for setting or getting the camera’s gamma values [camera ccu set gamma <value>;
camera ccu get gamma].
•
Serial command to retrieve the camera’s IP address: [81 09 08 4E 00 00 FF].
•
Ability for IR commands to forward over the HDBaseT connection.
•
Advanced streaming settings for enhanced compatibility with VPN environments.
•
Ability to configure MTU setting for IP streaming packets.
Improvements
•
Improved HDBaseT link negotiation.
•
Enhanced support for USB joystick control.
•
Update for Codec Control Mode improving camera fous when used via some third-party codecs.
•
Discontinued support for DES and 3DES cyphers and TLS v1.0 protocol. More recent cyphers and
protocols continue to be supported.
•
Main navigation bar of the web interface now has tooltips when collapsed.
•
Iris gain is now shown in dB values in web interface.
•
IR address DIP switch behavior now more closely reflects documentation.
•
Improved internal firewall settings.
•
Camera’s Pan/Tilt controls now invert to normalize control when Image Flip is On.
•
Soft DIP changes no longer execute while camera is in standby, which could previously cause issues
when coming out of standby.
•
Improved timing of serial response when camera has completed certain commands.
•
Updated syntax for “network ping count” Telnet command.
•
Web interface populates page information even more quickly.
Notes
•
If the camera’s custom Home preset takes an extremely long time to execute (>45 seconds), the camera
may not fully exit standby. Storing the Home preset with a faster speed will solve this issue.
•
Sometimes after updating from an older version of firmware the camera’s IR service will fail to start during
the first boot after the update. This error can be cleared by power cycling the camera.
RoboSHOT 12/30 HDBT 1.2.0
December 8, 2017
New Features
•
Added Codec Control Mode for Polycom® 3xx/5xx/7xx series codecs.
•
Added Codec Control Mode for Cisco® sX20 and SX80 series codecs. (Note: for SX20 codecs, Vaddio
recommends the codec’s firmware be updated to latest “CE” series firmware for best operation).
•
Soft DIP switch and Telnet command to allow disabling of the front LED.
Improvements
•
Updated time zone information.
•
Ability to import configurations from previous versions of software.
Notes
•
If previously selected time zone is deprecated during a time zone information update, the settings for the
camera will default back to UTC.
