system factory-reset
Gets or sets the factory reset status. When the factory reset status is on, the system resets to factory
defaults on reboot.
Synopsis
system factory-reset { get | on | off}
Options
get
Returns the camera's current factory reset
status.
on
Enables factory reset on reboot.
off
Disables factory reset on reboot.
Examples
>
system factory-reset get
factory-reset (software):
off
factory-reset (hardware):
off
OK
>
Returns the factory reset status.
This evaluates the most recent
system factory-reset
on or off command, if
one has been received, then reads the rear panel DIP switches and returns the
status
on
if they are all in the down position.
>
system factory-reset on
factory-reset (software):
on
factory-reset (hardware):
off
OK
>
Enables factory reset upon reboot.
Note
This command does not initiate a factory reset. The factory reset takes place on the
next reboot.
version
Returns the current firmware version.
Synopsis
version
Example
>
version
Commit:
d033ddb2378357a871011eb820706dcaa64ec0e2
Pan Motor Version:
0.2.4772
Sensor Version:
02.00
System Version:
RoboSHOT 2.3.0
Tilt Motor Version:
0.2.4772
OK
Returns current firmware version information. Your camera may return slightly
different information.
87
Complete Manual for RoboSHOT 12 and RoboSHOT 30 Robotic PTZ Cameras
