Using the Remote Control
The remote provides basic camera control. Some additional functionality is available from the non-
administrative web interface.
What do you need to do?
Button(s)
Power on or standby
Power
(green button at top right)
Select the camera to control (if
this remote controls more than
one)
Camera Select
buttons 1 through 3
(second row on the remote)
Discover the camera's IP address
Data Screen
button (top left) – press and
hold for 3 seconds
Move the camera
Arrow buttons and
Home
button (dark
red)
Move the camera to a preset
position
Position Preset
buttons 1 through 6
(bottom two rows)
Focus the camera
Auto Focus
button (near arrow buttons)
Manual Focus
buttons
Near
and
Far
(below Zoom Speed buttons)
Mute the microphone(s)
Mic Mute
button (center)
Change the speaker volume
Volume
buttons (center left)
Change zoom
Zoom
buttons –
T
(telephoto) to zoom in
and
W
(wide-angle) to zoom out. (center
right)
Adjust for excess light behind the
camera's subject
Back Light
button (top center)
Correct a motor calibration fault
condition (blinking yellow light)
Pan-Tilt Reset
button (center right, beside
arrow buttons)
Storing a Preset Using the Remote
Set up the shot using the pan, tilt, and zoom controls. Then hold down the
Preset
button and press one of the
numbered preset buttons.
Clearing a Preset Using the Remote
Press and hold the
Reset
button while pressing the preset number you want to clear.
2
