Disclaimer:
Products in this specification manual must by regulation be installed by licensed and registered trade people. The manufacturer/distributor
reserves the right to vary specifications or delete models from their range without prior notification. Dimensions and set-outs listed are
correct at time of publication however the manufacturer/distributor takes no responsibility for printing errors.
The pump is designed to be used with clean water
in a residential application. Do not use it with
alternative fluids, specifically abrasive, corrosive
or explosive fluids. Do not install or operate your
pump in an explosive enviroment or near
combustible matter.
Liquid may be HOT, release pressure with care
before servicing.
The pump operator or owner must be provided
with this owner’s manual. This must be read before
operation, and followed during operation.
DO NOT RUN PUMP DRY
Ensure that your pump is submerged in water
before operating.
Pump should only be serviced by qualified
personel. For best results, use only genuine service
parts. Be sure to prime pump before starting.
To avoid dangerous or fatal electrical shock hazard,
turn OFF power to motor and remove plug from
power outlet before working on pump or motor.
OPERATION
SERVICE AND MAINTENANCE
START-UP/OPERATION CHECK
When the power is turned on, put a small amount of water in the tank/pit/well, enough to cover the pump completely. The float switch will rise,
the pump will start and empty the pit. As the pit emties, the float switch will fall and the pump will stop.
The system is now working correctly. If no water is delivered, check the troubleshooting section.
GENERAL CARE AND MAINTENANCE
Under normal conditions V150 pumps do not need any type of maintenance. In order to avoid possible failures, it is advisable to periodically
check the pressure supplied and current absorption. A decrease in pressure is a symptom of wear. An increase in current absorption is a sign of
abnormal mechanical friction in the pump and/or motor.
If the pump is not going to be used for long periods of time it should be emptied completely, rinsed with clean water and put in a dry place.
VADA - V150
