MANUAL CONTROL OPERATION
1. Start in the OFF position (Fig. 1-6).
Fig. 1-6
2. Turn the lever so the arrow points to LIFT (Fig. 1-7) to
create vacuum on the pad. Once the gauge reaches 22
it is safe to lift the load.
Fig. 1-7
3. To release the load, turn the lever so that the arrow
points to RELEASE (Fig. 1-8).
Fig. 1-8
4. Once the gauge reaches zero the pad can be removed
from the object it was lifting.
5. Turn the switch back to the OFF position.
WIRELESS REMOTE CONTROL OPERATION
Fig. 1-9
GETTING STARTED
1. Press any button to begin operation. This will activate
the transmitter and receiver on the matched equipment
at the same time.
2. The green LED light (Fig. 1-9, 1) on the transmitter
will blink 2 times per second when the transmitter and
receiver are communicating. It will blink 1 time per
second if there is no communication (i.e. no power to
the CM 3/SL 2).
3. The red LED light (Fig. 1-9, 2) on the transmitter will
blink if the battery is low and should be replaced.
OPERATION
1. The transmitter is configured for two-handed operation.
2. To create vacuum on the pad to lift the load, lower the
pad onto the material and hold blue button and press
top red button (Fig. 1-9, 3) for 1-2 seconds. The CM 3/
SL 2 will continue to build vacuum after you release the
buttons.
3. Once the vacuum gauge is in the green range, it is safe
to lift the load.
Cm series
Operation
1
2
3
4
