Seite 11 von 12 // page 11 of 12
Das Dokument darf nur vollständig und unverändert verwendet und weitergegeben werden. Es liegt in der Verantwortung des
Anwenders, die Gültigkeit dieses Dokumentes bezüglich seines Produktes sicher zu stellen. 999195 // 05/02/2008
Documents are only to be used and distributed completely and unchanged. It is strictly the users´ responsibility to check carefully
the validity of this document with respect to his product. 999195 // 05/02/2008
Notes concerning the catchpot at the inlet (AK)
The catchpot at the inlet prevents droplets and particles from entering the pump.
- Lifetimes of diaphragms and valves are enhanced.
- Improves vacuum in case of condensation.
- The round bottom flasks are coated with a protective layer to prevent disintegration in case of break-
age or implosion.
• In case of condensation: Check liquid level in both catchpots during operation. Avoid overflowing of
the catchpots. Do not overfill the catchpots. Maximum liquid level approx. 80%, to avoid problems
when removing the catchpots.
• Check liquid level in both catchpots regularly and drain catchpots in time.
Removing the catchpot at the inlet:
Admit air or inert gas (via inlet of pumping unit) to atmospheric pressure.
Remove joint clip, remove catchpot and drain condensate.
Reassemble drained catchpots.
Important:
Comply with regulations when disposing solvents/condensates. Reuse if possible, purify if
contaminated.
