68 vacon
control keypad
Local contacts: https://www.danfoss.com/en/contact-us/contacts-list/
7
=
Menu button right
Move forward in menu.
Move cursor right (
Enter edit mode.
=
Start button
Pressing this button starts the motor if the keypad is the active control
place. See Chapter 7.3.3.
=
Stop button
Pressing this button stops the motor (unless disabled by parameter
R3.4/R3.6). See Chapter 7.3.3.
7.3
Navigation on the control keypad
The data on the control keypad is arranged in menus and submenus. The menus are used for the
display and editing of measurement and control signals, parameter settings (see Chapter 7.3.2) and
reference value and fault displays (see Chapter 7.3.3.4). Through the menus, you can also adjust the
contrast of the display (see Chapter 7.3.6.6).
The first menu level consists of menus M1 to M7 and is called the
Main menu
. The user can navigate
up and down. The desired submenu can be entered from
. When there still are pages to enter under the currently
displayed menu or page, you can see an arrow ( ) in the lower right corner of the display and can
reach the next menu level by pressing
The control keypad navigation chart is shown on the next page. Please note that menu
M1
is located
in the lower left corner. From there you will be able to navigate your way up to the desired menu
using the menu and browser buttons.
You will find more detailed descriptions of the menus later in this chapter.
Location
Description
Number of items
available
V1
è
V14
READY
Local
RUN
Monitor