Vacon 50X, User Manual

Page: 60 / 132

59 vacon vacon 50x parameters
Tel. +358 (0)201 2121 • Fax +358 (0)201 212205
7
7. Vacon 50X Parameters
7.1 Introduction
The Vacon 50X AC drive incorporates a comprehensive set of parameters that allow you to configure the
device to meet the special requirements of your particular application.
Note that pressing the PROG key enters Level 1 programming. Press SHIFT+PROG to enter Level 2 pro-
gramming. Press ENTER+PROG to show only those parameters that have changed from the factory de-
fault values.
This chapter describes the available parameters and the values that may be assigned to them. The pa-
rameter summary table on page 113 provides a summary of all parameters including their ranges and
default values.
7.2 Level 1 Parameters
The most commonly configured Vacon 50X parameters are stored in a group named Level 1. This group
is easily accessed by pressing the PROG key as described in “Keypad Operation and Programming” on
page 39. The following table lists the parameters in this group; for further information on the parameter,
please turn to the indicated page.
Para. # Parameter Name
See
Page
Para. # Parameter Name
See
Page
001 Model Number 60 301 Min Frequency 67
010 Last Fault 60 302 Max Frequency 67
102 Output Freq 61 303 Preset Freq 1 67
103 Output Voltage 61 402 Accel Time 1 68
104 Output Current 61 403 Decel Time 1 68
105 Drive Load 61 502 Voltage Boost 72
106 Load Torque 61 610 Timed OL Select 78
107 Drive Temp 61 700 Vmet Config 79
111 DC Bus Voltage 62 705 Relay 1 Select 80
201 Input Mode 62 706 Relay 2 Select 80
202 Rev Enable 63
Table 23:Parameters Available in Level 1 Programming (Factory Macro)