Vacmaster VZA0708P, Original Instructions Manual

Page: 10 / 20

10
GB
UNPACKING AND CHECKING CARTON
CONTENTS
ASSEMBLY
1. Remove all the contents from inside of the vacuum cleaner collection tank.
2. Remove the pre-installed pre-filter, and fully fit the dust bag flange onto the inlet stub
(Fig. 1). Place the pre-filter back into the container (Fig. 2).
NOTE:
Ensure the bag and filter are always fitted before use.
3. Fit the power head back onto the collection tank by securing the two latches (Fig. 3). Ensure
the power head sits properly on the collection tank and is correctly sealed.
4. Attach the locking end of the hose into the suction port of the container and turn clockwise to
tighten (Fig. 4).
5. Choose the desired accessories and/or extension wands and push and twist onto the hose
nozzle (Fig. 5).
1 Power Head 9 Carry Handle 17 Crevice Tool
2 Latch 10 Exhaust Filter Cover 18 Round Dusting Brush
3 Rear Wheel 11 Floor Nozzle Storage 19 Pre-filter (pre-installed)
4 Front Caster 12 Accessory Storage 20 Extension Wand (x2)
5 Suction Inlet Port 13 Power Cable 21 Exhaust Filter (pre-installed)
6 Collection Tank 14 Suction Hose 22 Instruction Manual
7 On/Off Switch 15 Floor Nozzle
8 Cable Rewind 16 Dust Bag (x5)