6 7
Position II switches the vacuum cleaner to stand by so that it switches on
and off automatically with a power tool that is plugged into the on-board
socket. Once the electrical appliance has been switched off, the vacuum
cleaner switches off following a time lapse to allow the suction tube to be
emptied.
Switching off the vacuum cleaner:
Press
D
RY-VACUUM OPERATION
DRY VACUUMING
WARNING: BE SURE TO READ, UNDERSTAND, AND APPLY
INFORMATION, ENTITLED ‘SAFETY INSTRUCTIONS & WARNINGS’.
DO NOT VACUUM IN AREAS WITH FLAMMABLE GASES, VAPORS, OR
EXPLOSIVE DUSTS IN THE AIR. FLAMMABLE GASES OR VAPORS
INCLUDE BUT ARE NOT LIMITED TO; LIGHTER FLUID, SOLVENT
TYPE CLEANERS, OIL-BASE PAINTS, GASOLINE, ALCOHOL OR
AEROSOL SPRAYS. EXPLOSIVE DUSTS INCLUDE BUT ARE NOT
LIMITED TO; COAL, MAGNESIUM, GRAIN OR GUN POWDER. TO
REDUCE THE RISK OF HEALTH HAZARDS FROM VAPORS OR DUST,
DO NOT VACUUM TOXIC MATERIALS.
CAUTION:
• Do not vacuum drywall dust or fireplace soot or ash with standard Wet
and Dry filter. This is a very fine dust which will not be captured by the
filter and may cause damage to motor. When vacuuming fine dust use
a dust bag for fine dust (sold separately) in addition to the cartridge filter
and cartridge pre-filter.
WARNING: DO NOT PLUG IN POWER CORD TO POWER SOCKET.
MAKE SURE PLUG IS DISCONNECTED BEFORE CHANGING AND
CLEANING FILTERS.
1. Verify that the power cord is disconnected from the power socket. (fig.1)
2. In order to prepare your vacuum cleaner for dry vacuuming, verify that
the cartridge filter is securely mounted. With power head removed and in
the upside down position, make sure the filter is pushed in until it stops
against the power head and the retainer is installed. (fig.2 & 3) (Your wet
and dry vacuum cleaner comes with the cartridge filter pre-installed, if
not, see page 9 for installation instructions.)
3. Optional, for improved dust filtering, fit dust bag flange onto the inlet
stub, taking care not to damage the bag. (fig.4)
4. Position the pre-filter in the tank. Place the power head back on the
container, and secure it in place using the latches. (fig.5)
OPERATING INSTRUCTIONS: DRY VACUUMING
5. Insert the locking end of the hose (marked with an arrow) into the
relevant port of the vacuum cleaner and turn to lock into place. Push the
required attachment onto the free end of the hose or extension. (fig.6)
6. Plug in the power cord into the power socket. (fig.7)
7. Turn the motor on by flipping the switch to the ‘I’ ON position. (fig.8)
8. Once you have completed vacuuming, flip the switch to the ‘O’ OFF
position and unplug the power cord from the power socket.
I = ON
II = ON/OFF with a power tool
Middle position = OFF
DO NOT USE THE CARTRIDGE FILTER FOR LIQUID VACUUMING
DO NOT USE A DUST COLLECTION BAG FOR LIQUID VACUUMING
1
6
7
8
2
3
4
5
