Vacmaster VOC1218PF, Original Instructions Manual

Page: 8 / 16

8
GB
Floor Nozzle Attachments
1) To remove the floor nozzle attachment, release the push clips on either side of the floor head
holder. The attachment should drop out from underneath (Fig. 6).
2) To insert a new floor nozzle attachment, place one side of the attachment into the bottom of the
floor head holder and secure one clip in place. Push the other side up into place and ensure it
is securely fitted into the holder (Fig. 7).
Hard Floor Nozzle:
Attachment is suitable for wet or dry suction on hard floor surfaces. Ensure the squeegee is
located towards the back of the floor head holder and brushes towards the front.
Artificial Grass Tool:
Attachment is specifically designed for use on artificial lawns. Ensure the front lip is facing away
from the user and in the direction of vacuuming.
OPERATION
1. Switching On/Off
Connect the mains plug to a suitable a power outlet.
Position Status
I on
O off
2. Wet & Dry Vacuum Operation
WARNING: ENSURE YOU READ, UNDERSTAND AND APPLY SECTION ENTITLED
‘SAFETY INFORMATION’.
1) Verify that the washable filter and pre-filter are installed and the container latches are secured.
2) Secure the locking end of the hose into the vacuum suction port.
3) Push the desired accessories onto the hose nozzle. The air flow regulation allows you to
change vacuum cleaner suction. For best cleaning results, fully close the air flow regulation (Fig.
8).
4) Plug the power cord into a power outlet.
5) Turn on the motor by assigning the switch to the “I” ON position.
6) Once you have completed vacuuming, switch to the “O” OFF position and unplug the power
cord from the power.
NOTE : If vacuuming a mixture of wet and dry surfaces, fully clean and dry the filter and collection
tank after each use.
Installing Cartridge filter:
WARNING: BEFORE INSTALLING, REMOVING OR CLEANING THE VACUUM
CLEANER FILTER, ENSURE THAT THE POWER CORD IS UNPLUGGED AND
SWITCHED OFF.