12
BLOWER OPERATION
WARNING: ALWAYS WEAR SAFETY GOGGLES COMPLYING WITH ANSI Z87.1 (OR IN
CANADA, CSAZ94.3) BEFORE USING BLOWER.
WARNING: KEEP BYSTANDERS CLEAR FROM BLOWING DEBRIS.
WARNING: WEAR A DUST MASK IF BLOWING CREATES DUST THAT MIGHT BE
INHALED.
IMPORTANT!
When vacuuming large quantities of liquids, do not immerse the nozzle completely
in the liquid; leave a gap at the tip of the nozzle opening to allow air inflow. The machine is fitted
with a float valve that stops the suction action when the collection tank reaches its maximum
capacity. You will notice an increase in motor speed. When this happens, turn off the machine,
disconnect from power supply, and drain the liquid into a suitable receptacle or drain. To continue
vacuuming, refit the power head to the collection tank. After wet vacuuming, turn the machine
off and remove plug from power supply. Empty the collection tank, clean and dry the inside and
outside before storage.
REMEMBER!
The foam wet filter must be removed after wet vacuuming and the cartridge filter
must be installed before dry vacuuming again.
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Make sure the collection tank is empty before using as a blower. Clear all dirt and debris from
the hose and collection tank.
3. Remove the hose from the vacuum port.
4. Insert the larger end of the hose into the blower port on the back of the power head and lock
into place (Fig. 2).
5. Choose the desired accessory and insert onto the end of the hose (Fig. 3).
This Wet/Dry Vacuum has blowing capabilities. To use the blower feature follow the instructions
listed.
3
4
1
2
5
6
7
Summary of Contents for VJF607PF 1101
Page 17: ...17 EXPLODED VIEW...
