92077r14
www.vac.se
V200 POSITIONER
4
2. FEEDBACK INSTALLATION
2.1 Connections
– Grounding point
1.
– Terminal block, switches
2 X 3 Connections
Maximum cable size AWG 11 (4 mm
2
)
2.
– Terminal block, Position Transmitter
Maximum cable size AWG 13 (2.5 mm
2
)
1
1
2.2 Front cover and indicator
2.2.1 Removing the front cover
Loosen the two screws(1) and
remove the front cover.
2.2.2 Removing the indicator
Pull the indicator(2) straight up, it is a friction fit.
Important Note!
Note the indicator’s position so it
can be installed in the same position.
Installing the indicator
Install the indicator in place over the drive
shaft and press it straight down.
Be sure to press the indicator completely down
so that it does not interfere with the indicator
cover (clear cover).
Turn the indicator to the proper display
position.
2
1
2
