5
INPUTS (back panel)
Inputs #1, #2, and Cinema may be either unbalanced or balanced. Three connections are
possible:
1) Single ended signal on RCA connector. Set adjacent switch to “RCA.”
2) Balanced signal on XLR connector. Set adjacent switch to “BAL.”
3) Single ended signal on XLR connector. Set switch to “BAL.” Alternatively, you may set the
switch to “RCA” if and only if the source is “pin 2 hot.”
One pair of RCA jacks accommodate the monitor return from a tape deck. If you do not
have a tape deck, these jacks can be used as an additional line level input. If using the tape
outputs, the TAPE OUT switch must be set to “ON.”
Two phono inputs are provided for "MC" and "MM" cartridges. The ground lead from the
turntable should be connected to the binding post located by these jacks.
OUTPUTS & GROUNDING SWITCH (back panel)
One pair of RCA jacks provide line level output to a tape recorder. The level of signal is not
adjusted by the volume control. If using the tape outputs, the TAPE OUT switch must be set
to “ON.”
Two sets of RCA output jacks are provided as main outputs to power amplifiers. In addition,
two pair of XLR jacks can be used to drive a power amplifier. The “OUTPUT MODE” switch
must be set accordingly. Only one mode may be used, i.e., you can not mix balanced and
single-ended power amplifier connections.
