INSTRUCTIONS
We are ready to get started building this Vac-U-Vee Jr. Follow the photos and captions to
assemble your boat. Read through the instructions before building. Assemble the necessary
tools and adhesives on a clean workbench or table. Keep paper towels handy to catch spills.
Don’t forget the safety glasses!
With holding the hull upside down on the
work surface, press a razor or hobby
knife into the corners at the marked trim
line.
Rock the razor left and right until it
cuts into the hull about this much.
Repeat for the two corners at the
stern.
Removing these corners will give you
a starting point for trimming with
scissors.
Cut with the boat on the right and the
scrap on the left. Don’t cut near the
tip of the scissors. If the tip of the
scissors closes on the plastic it could
cause a tiny crack.
While holding the liner firmly in place,
mark the edge to be trimmed with a
pencil. Trim the liner with scissors.
Set the Hull Liner into the trimmed
hull.
1
2
3
4
5
6
Trim the deck starting with the bow
and stern corners and your paint
scraper.
7
8
9
3
Pull down on the corners breaking
them off as shown. Trying to cut the
corners with scissors may split the
plastic.
