Vac-U-Vee Jr.
™
Mono Vee Hull Kit
Manufactured by Vac-U-Boat
™
1259 Humphries Rd.
Conyers, GA 30012
This “High Impact Polystyrene” model boat is engineered for racing. It has minimum
freeboard and an aerodynamic bow design to let it fly in straight-a-ways yet turn solid without
flipping. The deck comes from the 1/10-scale Vac-U-Cracker with a large hatch cover for easy
hardware installation. The hull is modified into a Deep-Vee with a sharp keel and a fully
reinforced bottom having the strength of a fiberglass hull without the weight.
The Full Kit includes a Hull, Hull Reinforcement, 3/16” hot-pressed mahogany plywood
Transom, Deck, forward Deck Reinforcement, teardrop Hatch Cover, Aluminum Motor Mount
with 3/16” hot-pressed mahogany Base with pre-installed 6-32 blind nuts, stainless motor
mount socket head screws, motor mount stainless washers, hex wrench, M3 motor socket head
screws, motor washers, motor hex wrench, molded Boat Stand with pre-cut foam mount pads,
an easy-to-apply combined windshield and roof hatch decal set, side decals, six deck
reinforcement clamps (clothes pins) two really cheap ratchet clamps, a wood scrap to clamp
the transom, an epoxy brush and a piece of 100 grit sandpaper.
The even-more economical Plastic Hull-Only kit includes the Hull, Hull Reinforcement,
3/16” hot-pressed mahogany plywood Transom, Deck, Deck Reinforcement, teardrop Hatch
Cover, Boat Stand and decal set. (No motor mount, no assembly bits.)
This hull will perform with a ROAR Stock brushed motor, or with the latest Brushless
setups. The reinforced motor mount slot allows for motor placement for flex drives or straight-
shaft drive systems. The transom will accommodate most struts and rudders made for smaller
boats. The sharp keel and makes turn fins unnecessary.
© 2012 Philip Pace dba Vac-U-Boat™
Length: 19-7/8 in. Beam: 7-3/8 in.
