9
Lay out the shelf inserts and anchor point inserts near where they go to avoid mistakes. Pour two 1-1/4-inch circles of 30
minute epoxy and mix. A steel shaft works well for this. A 1/8” diameter rod was used for these photos.
This is the correct Crossmember shelf insert for this side. It fits flush and evenly into the shelf. The anchor points inserts fit
any anchor point. Sand the insides of the two shelves and two inserts you marked and sand the corresponding sides of the
inserts that will go into the recesses.
Fold-in an equal volume of filler powder & mix well. Scoop up some and distribute around the inside of the chosen anchor
point. The insert is form-fit so little epoxy is needed.
Press the insert into the recess. Wipe away any excess epoxy. Repeat for the other anchor point and the two Crossmember
shelf inserts.
