V2 VEGA-24V, User Manual

Page: 64 / 148

E
N
G
L
IS
H
62
Automatic closing
During the automatic operation, the control unit will automatically close
the door when a set-up time expires.
The Start command, if enabled by
St.PA menu, allows closing the door
before the set up time expires.
In semi-automatic operation, that is to say, if the automatic closing
function is disabled by setting the value to zero ('
no ' will be displayed),
the door can be closed through the start command only: in this case,
St.PA menu setup will be ignored.
If the control unit receives a Stop command when the door is in
pause, it will automatically pass to the semi-automatic operation.
Closing after transit
During the automatic operation, the pause count down starts from the
set up value each time a photocell operates during the pause.
If the photocell operates during the opening time, this time will be
immediately stored as pause time.
This function allows having a fast closing as soon as transit through
the door is completed, therefore, a time shorter than
CH.AU is
generally used.
Ch.AU will be used when ‘ no ’ is set up.
As for semi-automatic operation, this function is not active.
Start command during the closing phase
This menu allows fixing the control unit conduct in case it receives a
Start command during the closing phase.
StoP The door stops and its cycle is considered as finished
APEr The door opens again
Select option StoP , to set up the “step-by-step” operation logic.
Select option APEr , to set up the ‘always open’ operation logic.
Start command during the pause
This menu allows fixing the control unit conduct in case it receives a
Start command when the door is open during its pause phase.
ChiU the door starts closing
no command is ignored
PAUS The pause time is restarted (Ch.AU)
Select option ChiU , to set up the “step-by-step” operation logic.
Select option ‘ no ’, to set up the ‘always open’ operation logic.
m
Apart from selected option, the start command lets the door
close if it has been stopped by a stop command or if the
automatic closing was not enabled.