ENGLISH
- 22 -
ADVANCED PROGRAMMING
To perform ADVANCED programming it is necessary to remove
the cover plate of the remote control and carefully follow the
dedicated procedures for the various functions.
Each function can be selected by entering a code during the
programming procedure; following is a summary table of the
functions with their relative programming codes.
A:
Code to activate programming
B:
Indicates channel 1 of the remote control; for channel 2 the
number is 12, for channel 3 the number is 13, etc. up to
channel 6
C:
Code of the function to be programmed
The pictures that follow include references to the buttons and the
LEDs used during programming.
L1
L2
L3
L4
L5
L6
UP
STOP
DOWN
PROG
TRANSMITTERS OF THE RANGE
ADLER
Using a transmitter of the range ADLER it is possible changing the
functions of the control unit controlling the tubular motor.
QUICK STORAGE OF THE TRANSMITTER
m
CAUTION
: the first transmitter recorded determines the
direction of the motor’s movement.
m
CAUTION
: If the sunshade has a casing, record the first
remote control by following the procedure “1. Record the
transmitters and select the sunshade mode”
To record remote controls for a new control unit that drives
a shutter or a sunshade (NOT with casing) proceed as
follows:
1.
Power only the control unit to be programmed
2.
Press and hold down UP and DOWN until the motor starts to
move in a direction
3.
Release the buttons: the motor will stop
4.
Press UP or DOWN following the direction the roll-up shutter
moved prior to stopping:
- if the roll-up shutter was rising, press UP; direction
acquired: the UP button raises the roll-up shutter, the
DOWN button lowers the roll-up shutter
- if the roll-up shutter was lowering, press DOWN;
direction acquired: the DOWN button lowers the roll-up
shutter, the UP button raises the roll-up shutter
5.
End of programming
To add other remote controls, proceed as follows:
6.
Press and hold down the UP and DOWN buttons of a remote
control that is already recorded until the motor starts to move
in a direction
7.
Release the buttons: the motor will stop
8.
Press the UP or DOWN button on the new remote control
CODE
FUNCTION
A
B
C
12 11 11 NOT USED
12 11 12 Storage of the transmitters
12 11 13 Deletion of all the stored transmitters
12 11 14 Programming of opening limit switch
12 11 15 Programming of closing limit switch
(closed louver blades)
12 11 16 Programming of opening position of adjustable
louver blades
12 11 17 NOT USED
12 11 18 NOT USED
12 11 21 NOT USED
Summary of Contents for LEX-RFO
Page 3: ...3 Fig 3 Fig 2...
