V-ZUG UnimaticDry V2000, Operating Instructions Manual

Page: 8 / 44

2 Using for the first time
2.1 Note
If the location of the appliance is changed, because of the heat pump it must stand
in its final position for around 2 hours before it can be operated again. Failure to
do this can result in damage to the appliance.
The appliance must be installed and connected to the electricity supply in accordance
with the separate installation instructions. Have a qualified fitter/electrician carry out the
necessary work.
2.2 Function description
When the appliance is connected to the power supply for the first time, it is possible to
select a function test. The purpose of the function test is to check the installation. It takes
about 3 minutes. The function test can be selected immediately after installation. The
heat pump is not started during the function test. Before the definitive initial start-up of
the appliance, it must stand in the normal operating position for around 2 hours, other-
wise the heat pump could become damaged.
The function test cannot be aborted by interrupting the power supply.
Once the function test has been run or aborted, it can no longer be selected and
the appliance enters the normal selection mode.
2.3 Starting the function test
▸ Connect the appliance to the mains and wait for to appear in the display.
▸ Use the button to start the function test.
The function test can be interrupted in two ways:
▸ Open the appliance door
.
– flashes in the display.
The indicator light for the button flashes after closing the appliance door.
Or:
▸ Press the button.
– The indicator light for the button flashes.
Continuing the function test:
▸ Press the
button.
– The duration remaining appears in the display, e. g. .
Aborting the function test:
▸ Pressing the button aborts the function test and all displays go out.
End of function test:
All the displays go out when the function test has finished.
8