Installation instructions
Toptronic
GK45TE
Glass ceramic hob
1039710-R02
05/03/2019
1039710-R02
7
Installation
1.
Create an accurate installation cut-out.
– The mounting surface can be reamed out or created by installing wood/stone supports or using the steel angle set (see Accessor-
ies).
Access to the appliance from below via the entire cut-out area must be guaranteed. For servicing purposes, the induction gen-
erator can be removed from below with the mounting plate. It must be possible to unscrew the contact-proof covers from be-
low.
2.
Prepare the cut-out and appliance in accordance with the specifications in the enclosed cementing-in instructions.
3.
Carefully cement the appliance in and leave the silicone sealant to dry for at least 24 hours.
4.
Connect to the electrical mains connection before inserting the appliance, if necessary.
Installation with oversize mounting frame
The layout of the hob to be fitted may differ from the hob illustrated!
600
54
5
X
X
560–58
5
600/55
0
490–5
30
=
=
A
Ri
Ra
GK45TESU, GK45TESUO
750–775
490–
530
600/550
=
=
B
A
790
Y
Y
545
Ri
Ra
X – X
≥20
*
550
B
H
Drawer/cabinet
H
≥20 *
Drawer/cabinet
Y – Y
GK45TEASU
Cable length 1.7 m
Cable length 1.7 m
L
K
Centering mark,
rear, middle of cut-out
Centering
marks, front
K
M
Centering mark,
middle of cut-out
Set of fixing brackets for
special installation cases
* The required clearance must be observed!
Type
A Depends on producer
B
H
Corner radius Ra/Ri
GK45TESU, GK45TESUO,
GK45TEASU
≥20 mm
≥54 mm
45 mm
10/8 mm
A
Worktop depth (in combination with directly built-under oven; does not apply to small appliances)
B
Required clearance for ventilation and service replacement over the entire cut-out area.
H
Dimension from the top of the work surface to the underside of the hob (ventilation opening)
Ri
Corner radii of appliance
Ra
Outer corner radii of cut-out
Installation with wood covers
1.
Create the mounting cut-out accurately.
2.
Centre installation rails
K
and
L
and fix in the mounting cut-out using the wood screws
M
as per the drawing.
3.
Installation with bevel:
Before installation of the hob, all stops
N
must be dismantled.
4.
Potentially connect to the electrical mains connection before inserting the appliance.
