Installation instructions
Toptronic
GK45TE
Glass ceramic hob
1039710-R02
05/03/2019
1039710-R02
3
Electrical connection
Electrical connections must be carried out by qualified personnel in accordance with the guidelines and standards
for low-voltage installations and the specifications of the local electricity supply companies.
Refer to the identification plate for information on the required mains voltage, current type and fuse protection.
A plug-in appliance may only be connected to a socket outlet with earthing contact, installed according to specifications. An
all-pole mains isolating device with 3 mm contact opening should be provided in the house wiring system. Switches, plug and
socket devices, circuit breakers and fusible cut-outs which are accessible after installation and which have all-poles switching
are permissible as isolating devices. Effective earthing and separately installed neutral and earth conductors ensure safe and
fault-free operation. After installation, live parts and cables with basic insulation must not be accessible. Check old installa-
tions.
▸
If the hobs are used at an altitude of over 2,000 meters above sea level, a reduced performance must be expected.
The appliance is equipped with a connection cable which must be connected to an on-site junction box.
Installation pipe
Distribution box
Clamp
400V~ 2
PE/
400V 2N~
230 V~
400V~ 3
PE/
PE/
PE/
yellow/ green
black
brown
L2
grey
yellow/ green
L3
grey
L2
black
L1
brown
L1
N
blue
L1
brown
L2
black
yellow/ green
N
blue
L1
brown
yellow/ green
Error message U400
Faulty connection:
A pole conductor has been connected to the connection terminal for neutral conductors.
Quickly disconnect the appliance from the mains!
General information about installation
The distance from the appliance cut-out to flammable walls (left, right and rear) must be ≥50 mm. Parts such as side
walls and reinforcing strips which protrude into the installation space under the cooking zone must be made of non-
combustible materials.
It is recommended that a distance of 20 mm be maintained between the underside of the appliance tray and any part
of the cabinet beneath that is made of combustible material. If a drawer is installed directly underneath – and if the
tray can be reached from below without the aid of tools – protection against accidental contact must be ensured. The
thermal shielding plate set (see Accessories) is recommended for this purpose.
Note for for flush installation
▪
These appliances are typically installed in stone worktops.
▪
The worktop must be flat and at least 20 mm thick.
▪
The appliance is embedded in the cut-out made in the stone worktop by the producer (see accompanying cementing-in instructions).
Only use cementing-in material (black silicone) that is good, not old and achieves the necessary final strength and elasticity within a
24-hour curing time.
▪
A cement set and special primer are available for fitting in non-absorbent worktop materials (See Accessories).
