Installation instructions
Toptronic
GK45TE
Glass ceramic hob
1039710-R02
05/03/2019
1039710-R02
8
5.
Lower the appliance symmetrically into the mounting cut-out until it reaches the spring clips on the work surface. The connection
cable must not touch the hot areas of the tray located underneath the cooking zones.
Installation with stone covers
With stone covers, the installation rails
K
and
L
can be stuck into place (for adhesive see
1.
Clean/prime the bonding surfaces on the stone and installation rails well and leave to dry thoroughly.
2.
Apply the adhesive to the stone and smooth with a scraper. Apply a thin layer of activator to the bonding surface of the installation
rails.
3.
Centre the installation rails and press down on them firmly. Observe the recommended setting time of the adhesive used.
4.
Installation with bevel:
Before installation of the hob, all stops
N
must be dismantled.
5.
Potentially connect to the electrical mains connection before inserting the appliance.
6.
Lower the appliance symmetrically into the mounting cut-out until it reaches the spring clips on the work surface. The connection
cable must not touch the hot areas of the tray located underneath the cooking zones.
The appliances with oversize frames can also be used as a replacement for solid plate hobs and for installation in complete chrome-
nickel steel covers. In the latter case, the solid plate hob part is cut out of the chrome-nickel steel cover and replaced by an appliance
(depth of the work surface ≥30 mm). In contrast to normal installation without a fastening system, the appliance is fixed from below us-
ing adjusting braces.
Variable areas of the special cut-out dimensions
GK45TESU, GK45TESUO
GK45TEASU
560–585
490–530
=
=
(30)
6 adjusting braces
Aim for
≤R10
750–775
490–530
=
=
(30)
6 adjusting braces
Aim for
≤R10
Reinforcement of the cut-outs with
a complete chrome-nickel steel cover
Arrangement of the adjusting braces
≤25
≤32
E
D
40
30
(≤ screw length)
(≤ screw length)
Warning, glass breakage:
Do not overtighten screws
Reinforcing slats:
≥25 × 25 mm
Plate for chrome-nickel steel cover
The installation instructions with regard to electrical and safety-related issues remain fully valid for this installation.
1.
Make a precise, right-angled cut-out in the work surface (if not already present). Aim to keep the cut-out dimensions to a minimum.
2.
Securely clamp the appliance in the cut-out using the enclosed adjusting braces
D
and screws
E
. If necessary, install reinforcing
slats and use these to make the cover flat.