5 Trouble-shooting
4.4
Reset saturation indicator alarm
Reset the saturation indicator alarm for both the metal grease filter
and the activated
charcoal filter
after cleaning/replacing.
▸ With the appliance switched off, hold the
button depressed for 5 seconds.
–
If reset correctly, the
and
symbols are no longer displayed.
4.5
Replacing the LED light bulbs
For safety reasons, the LED light bulbs must be replaced by our Customer Services.
5
Trouble-shooting
This section lists faults that can be solved simply by following the instructions given. If
the fault cannot be remedied, please call Customer Services.
Before calling Customer Services: Please note down the serial number (for FN, see iden-
tification plate under «Technical data») and what led to the fault.
Malfunction
Possible cause
Solution
Appliance is not
working.
▪
An interruption in the
power supply.
▸ Check the mains power supply.
▸ Change fuse.
▸ Reset automatic circuit breaker.
Illumination is not
working.
▪
LED light bulb is defective. ▸ Contact Customer Services.
Malfunction
Possible cause
Solution
Appliance is not ex-
tracting enough air.
▪
Metal grease filters are
dirty.
▸ Clean metal grease filters.
▪
Recirculation mode only:
Activated charcoal filters
are saturated.
▸ Clean and reactivate or replace
activated charcoal filters.
▪
Extraction mode only: In-
sufficient fresh air intake.
▸ Ensure fresh air intake is suffi-
cient.
16
Summary of Contents for DFPQ5
Page 1: ...Operating instructions DFPQ5 DFPQ6 DFPQ9 DFPQ12 Range hood...
Page 21: ...21 Notes...
Page 22: ...22...