4 Operation
If the «Preheat» option has been turned on, do not put the food into the cooking
space until the acoustic signal is emitted and the corresponding message ap-
pears.
Before setting the delayed start,
▸ in the value range, touch «End».
–
The colour of the value range changes to amber.
▸ Set the desired end time using the CircleSlider.
–
The desired duration and the set end time ap-
pear in the display:
15min
13:21
▸ Press «Start» to start the delayed start.
–
The time set or remaining to the start of opera-
tion and the end of operation appear in the dis-
play:
15min
13:21
Appliance starts in: 32min
▸ If necessary, check and change the settings (see page 24).
–
Any changes to the «Operating time», «End», «Preheat» or «Core temperature» op-
tions cause the time remaining to the start of operation to be recalculated.
If «Operating time» has been set, the end time cannot be set or adjusted during
operation.
Example
▸ Select the
«Hot air» application and 180 °C.
▸ At 8:00, set an operating time of 1 hour and 15 minutes.
▸ Set the end time to 11:30.
–
The appliance switches on automatically at 10:15 and off again at 11:30.
4.7
Food probe temperature
Only use the food probe supplied.
Do not clean the food probe in the dishwasher. Always keep the plug clean.
The food probe is used to measure the temperature inside the food (referred to as the
food probe temperature). As soon as the food reaches the desired target temperature
(the food probe temperature that should be attained at the end of the cooking process),
operation stops automatically. It is also possible to simply measure the food probe tem-
perature without stopping operation.
For a correct food probe temperature reading, the food probe must as far as pos-
sible be fully inserted into the centre of the food.
The optimal target temperature depends on the cut of meat and on the degree of
doneness.
Refer to the information on target temperatures in «EasyCook».
22
Summary of Contents for CS6T-23034
Page 78: ...78 15 Notes...
