3 Operating the appliance
3.2
Intensive level
The intensive level can be selected in stand-by mode.
▸ Press the
button to switch the intensive level on for five minutes.
–
The
button and the button for the power level that was running when the intens-
ive level was started illuminate.
▪
If another power level had been running beforehand, then the appliance will automat-
ically revert to this power level after the five minutes has elapsed.
▪
If the intensive level was selected when in the stand-by mode, the appliance will
switch off after the five minutes.
▸ Press the
/ / or button to stop the intensive level before the five minutes has
elapsed.
3.3
Illumination
▸ Press the
button to switch the illumination on.
▸ Press the
button again to switch the illumination off.
3.4
Saturation indicators
Saturation indicator for the metal grease filters
The button flashes after 40 operating hours. The saturation level has been reached and
the grease filters must be cleaned.
Saturation indicator for the activated charcoal filters
The saturation level is reached when the button flashes or within four months at the
latest. Depending on use: Replace the standard activated charcoal filters or clean and re-
place long-life activated charcoal filters.
Resetting the filter saturation indicator
▸ In the stand-by mode, hold the
button depressed until an acoustic signal is emitted.
–
The flashing LEDs (grease filters) or (activated charcoal filters) no longer flash.
3.5
Stand-by
Deactivating the stand-by mode
▸ Hold the
button depressed for three seconds.
–
The appliance is switched off and the LED
goes out.
This function is useful when cleaning the hood. The illumination can also be used
when the stand-by mode is activated.
Activating the stand-by mode
▸ Hold the
button depressed for three seconds.
–
The stand-by mode is activated and the LED
illuminates.
9
