![background image](http://html2.mh-extra.com/html/v-zug/adoradry-v6000/adoradry-v6000_installation-instructions-manual_3092220006.webp)
Installation instructions
Heat pump dryer
One-family household
1068340-06
03/10/2022
1068340-06
6
Preparing the electrical connections
General information
Electrical connections must be carried out by qualified personnel in accordance with the guidelines and standards
for low-voltage installations and the specifications of the local electricity supply companies.
A plug-in appliance may only be connected to a socket outlet with earthing contact, installed according to specifications. An
all-pole mains isolating device with 3 mm contact opening should be provided in the house wiring system. Switches, plug and
socket devices, circuit breakers and fusible cut-outs which are accessible after installation and which have all-poles switching
are permissible as isolating devices. Effective earthing and separately installed neutral and earth conductors ensure safe and
fault-free operation. After installation, live parts and cables with basic insulation must not be accessible. Check old installa-
tions.
▸
Use at altitude: Electrical safety is guaranteed up to 2,000 m above sea level.
▸
Refer to the identification plate for information on the required mains voltage, current type and fuse protection.
The mains plug must not be cut off.
Connection cable
Valid for all washing machines and tumble dryers in the Adora, AdoraWash and AdoraDry model range.
The mains cable may only be replaced by the manufacturer, its Customer Services or a similarly qualified person.
Error message «U1»
Disconnect the appliance from the mains and control the wiring.
Fastening the drain hose
When installing the drain hose, protect it against damage and kinks!
Where possible, the drain hose must be fastened with the hose clamp supplied. Do not use a hose clip as otherwise
the pump connection piece could get damaged.
Fasten the drain hose before plugging in the mains cable.
▸
Remove pump cover
1
.
▸
Fasten drain hose
2
to nozzle
4
using hose clamp
3
.
▸
Put back pump cover
1
.
1
3
2
4
▸
Fix drain hose
2
to the two lugs
5
with cable ties.
▸
Plug in the mains cable.
2
5
5