10 Trouble-shooting
Malfunction
Possible cause
Solution/Measures
Illumination is flash-
ing and an acoustic
signal is emitted.
▪
Appliance door is left
open for longer than 5
minutes.
▪
Appliance door was not
closed properly.
▪
Door sensor is faulty.
▸ Close the appliance door.
–
If the alarm is still being emit-
ted:
▸ Touch any button to acknowledge
the alarm.
▸ Check the door seal, contents and
installation situation for any ob-
structions.
–
After acknowledging 3×, an er-
ror message appears: A1.
▸ Contact Customer Services.
▪
The «TouchOpen» door
opening mechanism is
defective.
▸ If the door opener does not re-
tract, switch the appliance off for
about 10 seconds and then switch
it back on again.
▸ If the door opener still does not re-
tract, remove by pulling it out.
▸ Close the appliance door.
▪
The appliance door can be
opened manually (e.g. with a
standard suction cup).
▸ Contact Customer Services.
The temperature and
cooling zone(s) flash
and/or an acoustic
signal is emitted.
▪
The cooling compart-
ment temperature is
8 °C higher than the set
temperature.
▸ Touch any button.
–
The current temperature value is
displayed; the cooling zone(s)
flashes until the set temperature
is reached.
▸ If there is no warm bottle in the ap-
pliance: Contact Customer Ser-
vices.
▪
There has been a power
failure. The flashing tem-
perature display shows
the temperature when
the appliance is put
back into service.
▸ Touch any button.
–
The set temperature is shown in
the temperature display.
▪
The frequent appear-
ance of warnings indic-
ates a technical prob-
lem.
▸ Contact Customer Services.
Cooling compartment
illumination is on
when the door is
closed.
▪
Permanent interior illu-
mination is active.
▸ Deactivate permanent interior illu-
mination.
22
