V-TAC VT-6056-4, Instruction Manual, Page: 7 / 18

HALL BALL HANGER
CEILING CANOPY
SUPPORT ROD COUPLER
SAFETY PIN
MOTOR LEADS
RETAINING CLIP
& WASHER
SUPPORT ROD
COUPLER COVER
THREADED END
OF SUPPORT ROD
SUPPORT ROD
SET SCREWS
FAN MOTOR
ASSEMBLY
• The important safeguards and instructions appearing in the manual are not meant to cover all
possible conditions and situations that may occur. Please ensure to take caution and careful
attention to detail are factors which cannot be built into this product. These factors must be
supplied by the person or person installing, caring for and operating the unit.
• These instructions are designed for a number of similar but different ceiling fans. As you pro-
ceed, some steps may or may not apply to the fan purchased. Compare each step or optional
procedure to your fan and proceed accordingly.
• This fan is shipped with 1 down rod. 4" or regular ceiling application.
• The appliance is not intended to be used by children under the age of 8. It can be used by
children over the age of 8, as long as they are given continuous supervision.
• This appliance is not intended to be used by persons with reduced physical, sensory, or
mental capabilities, or lack of experience or knowledge, unless they have been given supervi-
sion or instruction concerning the use of the appliance in a safe way by a person responsible for
their safety, and understand the hazards involved.
• Supervise young children to make sure that they do not play with the appliance. Close super-
vision is necessary when the appliance is being used by or near children.
• Keep the appliance and its cord out of reach of children under the age of 8.
• Do not try to repair the appliance by yourself. Contact the official Technical Support Service
for advice.
• Cleaning and maintenance must be carried out according to this instruction manual to make
sure the appliance functions properly. Turn off and unplug the appliance before cleaning it.
• This appliance can be used by children aged from 8 years and above and persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge if they
have been given supervision or instruction concerning use of the appliance in a safe way and
understand the hazards involved. Children shall not play with the appliance. Cleaning and user
maintenance shall not be made by children without supervision.
Pull the electric wires in the junction box down through
the mounting bracket then bend them up and back out of
the way. Place the black wire to one side and the white
and ground wire to the other side (see figure 5). The wires
should be off to the side and up against the ceiling. This
will leave the mounting bracket open and ready to receive
the ceiling fan.
STEP 2. ATTACHING THE SUPPORT ASSEMBLY
• If you are using an extended support rod, (longer than
the one supplied with your fan) remove the halt ball
from support assembly and attach it to the extended
support rod at this point. Make sure to retighten the set
screw and insert the safety pin.
• Back off (loosen) the set screws (2) in the support rod
coupler until the inside of the channel is clear of the
screw tip.
• Remove and save the safety pin on the end of the
support rod assembly.
• Place the ceiling canopy face down (small end) over
the support rod coupler on the motor housing.
• Feed the electrical wire from the fan housing through
the support rod.
FIG. 5
FIG. 6