V-TAC VT-519 Installation Manual Download Page 2

Page: 2 / 4

INSTALLATION:

• Provide power to the required point of installation

• Remove the top cover as shown below in the image

• Using the top cover as a template, mark the location for, and drill 2 ﬁxing holes

ensuring not to infringe with any joists, gas or water pipes or electrical cables.

• Feed the mains cable through the cable entry hole in the top cover.

• Connect mains cable into push-ﬁt terminal block ensuring correct polarity is observed,

see the following ﬁgures for maintained, non-maintained and switched maintained

wiring diagram.

• Connect ﬂying lead from battery pack to the socket on the PCB.

• Reﬁt the exit sign to the top cover ensuring all 4 lugs lock into place.

• Switch on the power supply and ensure green LED indicator is illuminated

Summary of Contents for VT-519

Page 1: ...E Wiring Regulations BS7671 Please isolate mains prior to installation maintenance Check the total load on the circuit including when this luminaire is tted does not exceed the rating of the circuit c...

Page 2: ...ical cables Feed the mains cable through the cable entry hole in the top cover Connect mains cable into push t terminal block ensuring correct polarity is observed see the following gures for maintain...

Page 3: ...ation test simulate a mains supply failure for one hour continuous test by operation of key switch or switching o circuit breaker Ensure normal supply is restored after test and the indicator status L...

Page 4: ...ducts or solvents which may damage the tting GUARANTEE This product is only guaranteed against defects in manufacture The warranty is valid for two years from date of purchase The warranty does not co...