CODE OPERATION
F.
A three-gang wireless switch controls 3
wireless receivers
PAIRING THE SWITCH & THE RECEIVER
1. Connect the receiver between the light and the power source.
2. Power on electricity, press and hold the se�ng bu�on for 2 seconds. When the indicator light
flashes, it enters the matching code mode, then loosen your finger.
3. Press the wireless switch bu�on that you want to pair. Use the wireless switch to control the
light on or off, indica�ng that the learning code is successful.
NOTE:
(a) Not recommended that 1 switch controls many receivers.
(b) Ensure that there is no other pairing within 100 mtrs range to avoid interface.
ADDING ANOTHER SWITCH TO A PAIRED SWITCH
Press and hold paired switch panel for about 20s �ll LED indiator on switch blinks rapidly, then
loosen your finger, press the new one, finally test whether it can turn on/off the lamps.
G.
A hand remote control switch controls 3
wireless receiver.
