1) Adjust the lower part of the Tripod stand as shown in Fig 1. (Make sure the lower
part of the stand is in locked position before you proceed to further steps)
2) Install the floodlight (fixture) on the mounting bar as shown in Fig 2. Make sure it’s
fixed properly by installing the mounting screws. (Fixture not included)
3) Once the floodlight (fixture) is installed fix the mounting bar on the top of the stand
as shown in Fig 3. Make sure it’s fixed properly using the mounting screw. Please do
not over tighten the screw.
4) Stand height can be adjusted by using turning screws as shown in the Fig 5. Once
you loosen the screw you can increase or decrease the height as per requirement and
at the desired position tighten the turning screw (as shown in fig 4).
6) Once you have completed the above steps you can now power the floodlight
(fixture) (Floodlight/fixture not included).
Note:
Please switch OFF the power before starting the wiring installation of the
floodlight (Fixture)
INSTALLATION DIAGRAM
FIG 1
FIG 2
FIG 3
FIG 4
940~1800mm Adjustable
