Figure 1 Figure 2 Figure 3
2. Use
Note: before using the remote control, it is necessary to learn and match with the smoke alarm that needs to be
networked. Please operate in strict accordance with the following steps, otherwise the functions of the remote control
cannot be realized.
1) “Learn” operation for remote control and smoke alarm at the same time
Buckle the battery mounting plate of smoke alarm in place according to the operation mode described in VG-6622
series instructions.
Select a smoke alarm arbitrarily, press the "Learn" button twice, and the green indicator light will be on (as the
host).
Press the "Learn" button of other smoke alarms respectively, and the red indicator light will be on (as an
extension).
Press the "Locate" button on the remote control for 2 seconds, and the red indicator light will be on.
Press the "test / hush" button on the smoke alarm of the host, at this time, the red indicator light next to the "lean"
button of the smoke alarm flashes, and the indicator light changes from red to green after receiving the signal from
other extensions and remote controllers, and the smoke alarm will send out a loud alarm sound to complete the
learning.
2) Remote control independent learning
When the user has learned and matched the smoke alarm that needs to be connected to the network before, and
later he wants to add the remote control to the network, please follow the steps below to operate:
After confirming that the remote control has been powered up for normal operation, press the "locate" key
for 2 seconds, at this time, the red indicator light is always on.
press the "test" button on any previously networked smoke alarm, and the remote control will change from
the red light to the green light to complete the learning
3
）
Remote control function
TEST:
When you need to test the networked smoke alarm, press the "test" key for 2 seconds, and the green
indicator light is always on. When the smoke alarm within the communication range receives the signal, it
will send out a loud alarm sound, indicating that the smoke alarm works normally.
HUSH:
When the smoke alarm is alarmed due to the non real fire environment such as smoking, cooking and
environment, the remote control indicator light will flash red. You can press the "hush" button of the remote
control, and the smoke alarm will enter the mute mode for about minutes.
LOCATE:
When the smoke alarm give alarm and other networked smoke alarms also alarm, the user cannot
identify the location of the real smoke alarm which raise the alert. At this time, press the "locate" key of the
remote control, and the remote control will turn off other networked smoke alarms, only the real fire detected
