Assembly
Connect both Uprights (2) to the Upright Support Bar (3) using 4 x M8 x 50mm
Carriage Bolts (17) fitted from the inside as per illustration, 4 x M8 Flat Washers (23)
and 4 x M8 Nylon Locknuts (26).
Place both Uprights (2) on the outside of the Rear Stabiliser (1) and secure in place using 2 x
M8 x 85mm Carriage Bolts (19) fitted from the outside, 2 x M8 Flat Washers (23)
and 2 x M8 Nylon Locknuts (26).
Now attach both Stabiliser Brackets (13) to the inside of both Uprights (2) using 2 x M8 x
50mm Carriage Bolts (17), 2 x M8 Flat Washers (23) and 2 x M8 Nylon Locknuts (26),
and in between the Rear Stabiliser (1) and Squat Stand Tubes (52) using 2 x M8 x 85mm
Carriage Bolts (19), 2 x M8 Flat Washers (23) and 2 x M8 Nylon Loknuts (26).
Connect the Squat Stand Link Plates (54) to the INSIDE of each Upright and Squat Stand Tube
Using 4 x M8 x 50mm Carriage Bolt (17), 4 x M8 Flat Washer (23) and 4 x M8 Nylon Locknut
1
Note
PART No. DESCRIPTION . . . . . . . . . . . . . .
QTY
Assembly Accessories 1
17 M8 x 50mm CARRIAGE BOLTS . . . . . .
19 M8 x 85mm CARRIAGE BOLTS . . . . . .
23 M8 FLAT WASHERS . . . . . . . . . . . . . .
26 M8 NYLON LOCKNUTS . . . . . . . . . . . .
30
BARBELL LOCKING PINS . . . . . . . . . . .
(26) for each fitting. Now fit the Barbell Locking Pins (30) through the holes in the top of both
Uprights (2) as shown below.
Do not fully tighten at this stage.
10
4
14
14
2
Do NOT FULLY TIGHTEN any
Bolts, Nuts or Fittings at this
stage unless specifically
instructed to do so.
Note
Page 1
5
