Assembly
1
Carefully unpack each component, checking against the parts list that
you have all the necessary parts to complete the assembly of your
product.
Please note that some of the parts may be pre-fitted to major
components, so please check carefully before contacting our
CUSTOMER SUPPORT team.
In any event, please do not return the product to your retailer before
contacting us first.
Do NOT FULLY TIGHTEN any
Do not fully tighten at this stage.
Bolts, Nuts or Fittings at this
stage unless specifically
instructed to do so.
Note
Beny Sports Co. UK Ltd
Unit 8, Riparian Way,
The Crossings, Cross Hills,
West Yorkshire.
BD20 7BW
Tel:- 01535 637711 or
Fax:- 01535 637722 or
E-mail:- [email protected]
CUSTOMER SUPPORT is open from 9.00am to 5.00pm from Monday
to Friday
PART No. DESCRIPTION . . . . . . . . . . . . . . QTY
Assembly Accessories 1
17
M8 x 50mm CARRIAGE BOLT . . . . . .6
23
M8 FLAT WASHER . . . . . . . . . . . . . .10
26
M8 NYLON LOCKNUT . . . . . . . . . . . .10
30
BARBELL LOCKING PIN . . . . . . . . . . 2
44 M8 x 85mm CARRIAGE BOLT . . . . . . 2
45 M8 x 45mm CARRIAGE BOLT . . . . . . 2
Connect both Uprights (2) to the Upright Support Bar (3) using 4 x M8 x 50mm
Carriage Bolts (17) fitted from the inside as per illustration, 4 x M8 Flat Washers (23)
and 4 x M8 Nylon Locknuts (26).
Place both Uprights (2) on the outside of the Rear Stabiliser (1) and secure in place using
2 x M8 x 85mm Carriage Bolts (44) fitted from the outside, 2 x M8 Flat Washers (23)
and 2 x M8 Nylon Locknuts (26).
Now attach both Stabiliser Brackets (13) to the outside of the Rear Stabiliser (1) and to
the inside of both Uprights (2) using 2 x M8 x 50mm Carriage Bolts (17),
2 x M8 Flat Washers (23) and 2 x M8 Nylon Locknuts (26) and from the inside of the Rear
Stabiliser (1) using 2 x M8 x 45mm Carriage Bolts (45), 2 x M8 Flat Washers (23) and
2 x M8 Nylon Locknuts (26). Insert both Barbbell Locking Pins (30) through the holes in
the top of both Uprights (2) as shown below.
Page 15
