Assembly
Stage J.
21). Fit 1 x Pulley (68) And 2 x Pulley Bearing so the Floating Pulley Bracket (17) (Inset "E"), using 1 x M10 x 40mm Hex Bolt (26),
2 x M10 Flat Washers (38) and 1 x M10 Nylon Locknut (35).
22). Fit the remaining Pulley (68) to the Auxiliary Leg Pulley Bracket (17A) (Inset "F"), using 1 x M10 x 40mm Hex Bolt (26),
2 x M10 Flat Washers (38) and 1 x M10 Nylon Locknut (35). Fit this assembly to the Front Upright near the Backrest Frame - Front
Upright fixing bracket using, 2 x M10 Flat Washers (38) and 1 x M10 Nylon Locknut (35).
Note: - The Auxiliary Leg Pulley Bracket should be able to rotate when assembled.
23). Connect one end of the Leg Extension Cable (49) to the bracket on the back of the Leg Extension (Inset "G"), Iocating the
Leg Cable Pin (44) in the position. Fit a Carabina Clip to the other end of this Cable.
24). Take the THREADED end of the Weight Stack Cable (47) and pass it through the Auxiliary Leg Pulley Bracket fitted in Stage
J-22 above. Route this cable up the Front Upright and around the Pulleys shown in lnset "H" following the route in lnset
"I", over the rearmost Pulley and down into the Selector Shaft, securing in place by first fitting the M12 Top Plate Washer (37) then
tightening the threaded end of the cable securely in the Selector Shaft.
25). Take the LOOPED end of the Lat Cable (48) and pass it through the Top Lat Bar Bracket, Over the Top Front Lat Pulley,
Around the Top Rear Pulley, Down the rear of the Front Upright, Under the Lower Cross Beam Pulley, Over the Chest Press Bar
Pulley, Under the Rear Upright Lower Pulley then connect the Carabina clip (45) And Chain (72) to the Lat Cable end with
1 x M8 x 25mm Hex Bolt (73) and 1 x M8 Nylon Locknut (74) & 2 x Washers (39). Fit the Adjuster Chain (72), using the link that
reduces overall cable slack and hook onto the Floating Pulley Bracket (17). Once this cable is secure, fit the Lat Bar (15) to the
Carabina Clip and position the Lat Bar onto the rest hooks by the Front Lat Pulley.
Note: - To further reduce or increase cable slack in your system you can make fine adjustments by adjusting the bolt on the
Weight Stack Cable. Please ensure that at least 30% of the thread on this bolt is screwed into the Selector Shaft.
Page
22
Summary of Contents for Herculean LFG2
Page 2: ......
Page 26: ...Assembly Page 26...
