V.Bot M285DP, Operation Manual

Page: 17 / 28

GENERAL OPERATION
15
Starting Operation:
→
Manual work
※
When LED Indicator lights on.
→
Check:
Œ
. Dust bin is full.

. Intake Valve is stuck with dirt.
Ž
. Wipe out the inner and the outside of Intake Valve.
1. Be sure to clean up the dust bin.
2. Place the cleaner on place with more free space in the room.
3. When M285DP is working, two LED indicators " " and " " will flash one after
the other.
4. When the cleaner runs out of power, the “BATTERY LOW” LED lamp on the unit will be
red and the cleaner will automatically stop. And M285DP will emit a buzz of warning
indicating that the battery needs immediate recharging. The buzzer will sound every
minute until power is exhausted.
5. When the cleaner is not used or prior to recharge, make sure the power switch of
M285DP is in the
"
OFF
"
position.
6. When the dust bin is full, the "DUST BIN FULL" LED indicator the " " will light on
in RED.(Please refer to the diagram "LED INDICATOR" in page 12.)
※
Caution: Remove the dusting paper holder and side brushes before using on the carpet.
※
This product is not suitable for long-pile carpets.
Basic Operation:
1. Operation without connecting to the docking station:
Place the cleaner on the floor and turn on the power switch.
2. Operation via the docking station:
Turn on the power switch and connect the unit with the docking station.
A. While the unit connects with docking station, press “Full Go” button on the docking
station(Full Go light on). When M285DP detects the battery is fully charged, it will
leave docking station with Full Go light off and begin to work. Press again to cancel
the setting.
B. Press the “24H” button (24H light on) to set the starting time for the unit. The time user
presses the “24H” button is the daily starting time of the unit. Press again to cancel.
C. Pressing “Go” button on the docking station, the unit leaves docking station and starts
to work right away.
3. When battery low, the unit is programmed to move back to the docking station
automatically for auto recharge.
If the unit fails to return to the docking station, user can put it back to the docking station
manually.