5. INSTRUCTION FOR USE
5.1 BEFORE WEIGHING
Make sure that:
a. Connect the load cell signal and power to the
indicator properly
b. Place the scale on a level and strong surface
c. The scale is turned on
d. The
ZERO INDICATOR
is on. If not, press
ZERO
to set
display to zero
5.2 WEIGHING
a. Always place an object onto the scale gently
Excessive force applied to platter may cause damages
to weight sensor
b. The weight of the object is displayed on the indicator
automatically
c. It is a good practice to remove all loads from scale
after weighing. It would prolong the lifetime of
weight sensor
5.3 SELECT WEIGHT UNIT
Press
MODE
to shift between metric or avoirdupois weight
units. The weight unit used before power off would be
employed when the scale is turned on again.
NOTE:
To comply with the law of certain countries and certain
approval requirements, the avoirdupois weight units may
be disabled. Contact your dealer for more information.
5.4 TURN BACKLIGHT (OPTIONAL) ON/OFF
Follow the below steps to turn on and off backlight (if
purchased).
a. Scale is on
b. Press and hold
ZERO
until backlight is activated;
or press
MODE
to shift between metric and avoirdupois
weight to turn on and off backlight
Even though the backlight function is employed,
backlight will be automatically turned off when a stable
weight remained for 25 seconds or a zero weight is
detected and remains stable for 10 seconds
Backlight will be automatically turned on again when
a new weight is detected or when any key is pressed.
5.5 SET DISPLAYED VALUE TO ZERO WHEN UNLOADED
By pressing
ZERO,
weight displayed will be set to zero
and
ZERO INDICATOR
appears.
