32
4 Setting Up (Transmitter and Dive Computer)
II Uwatec
®
Aladin
®
Air Z
3.Open the tank valve. The transmitter briefly sends a pairing sequence to the
computer.
4.The dive computer shows a flashing <PAIr> in the display-position of tank pres-
sure shortly after the valve has been opened.
5.In order to confirm the pairing the B- and E- contacts have to be bridged. A bleep
confirms the input and <PAIr> is displayed permanently. The computer and trans-
mitter must remain in physical contact until the confirmation has been done.
6.Tank pressure is displayed after approximately 10 seconds.
7.In case of faulty pairing, the display <FAIL> appears instead of <PAIr>. In that
case, completely depressurise the regulator and repeat the pairing procedure.
This is only possible after at least 15 seconds.
– Pairing of transmitter and dive computer remains valid until a new pairing pro-
cedure is carried out. Pairing of transmitter and dive computer can therefore be
carried out at home and need only be executed once, before the first use. A
new pairing procedure is always necessary when a new transmitter or a new
dive computer is used and after changing the battery.
– Tank pressure shown in the lower part of the display of the dive computer
should be checked prior to every dive.
tank data
tank data
tank data
bar
10 s
tank data
Summary of Contents for Aladin Air z
Page 52: ...52 III Uwatec Aladin Air Z ...
Page 72: ...72 VI Uwatec Aladin Air Z ...