7
Assembly Instructions
Main Unit
Inspect the unit to ensure there are no broken lamps or
damaged parts. The handles should be secure and cord
assembly should have no cuts or damage, all wheels should
be in operating condition. UVC Cleaning Systems equipment
is a leased or sold so the unit received could be used/
refurbished and could have small cosmetic defects but
should have no broken or inoperable parts if it is leased.
Please contact UVC Cleaning Systems immediately if you
have received equipment that is defective. Each unit comes
completely assembled.
To
prepare
the device
for activation
, plug the
removable power cord
into the unit receptacle and into the power source
.
Ensure that the
circuit breaker is switched to the on position.
Press the desired time
you would like to run on the timing switch. When you press the desired
time, a light on the timer switch will turn on.
Exit the treatment
area and ensure no other people or pets are present.
Activate the device from outside the treatment area using the included
dedicated remote.
Always post warning signs at the
entrance
and exit
locations of the area you are treating.
Remote Control
The remote comes fully assembled and linked to the unit.
The range on
the remote is about 50 ft through one wall. The life of the battery is 3-6
months or longer depending on use.
Only the "A" button is used to
activate and deactivate the unit. The "B" button has no functionality on
this unit.
The battery is ins
talled and linked to the unit when shipped
. If a new
battery is needed, r
emove
the
battery door on back of remote.
Remove the battery housing, then the battery from its hosing.
Insert
one (1)
9V
alkaline battery into the remote. Make sure the polarity of
the batteries match the diagram on the inside of the
remote
. Reinstall
the battery
into the
hosing
then
replace
the
cover
.
If a new remote needs to be linked to the unit, locate the remote reset
hole on the front
top the unit within the warning label.
Plug the unit into a power source.
Prepare the unit by plugging into a
timing source, ensuring the circuit breaker is on, and activate the
timing switch to an on setting.
Use a small pin or other object to press
the reset button located inside of the housing. Hold the reset button
for 3 seconds. The reset button will flash on the inside of the unit fast.
Press the
"A"
button on the remote to link the unit. Once linked the
unit will activate and deactivate using the wireless remote.
