Upstream Instruction Manual
Released on 5/1/10 – R800001L
Page 21
UV Pure Technologies Inc. © 2010
3.
O
PERATING
I
NSTRUCTIONS
The Upstream applies advanced Crossfire Technology, yet is simple to operate.
The automatic quartz cleaning technology has been designed to reduce, and in
most cases, eliminate the periodic shutdowns necessary to inspect the
cleanliness of the quartz. The only required maintenance is the replacement of
the two UV lamps every 12 months (note - if you shut your system down for
seasonal use - the lamp life will be extended)
Unit Functions
AMBER LIGHT
WARNING CONDITION
RIGHT ARROW
ALSO "ENTER"
GREEN LIGHT
UNIT TREATING
RED LIGHT
ALARM CONDITION
UP ARROW
DOWN ARROW
LEFT ARROW
LCD DISPLAY
Figure 2
There is an LCD display, four pushbuttons, and three indicating lights on the front
panel. See Figure 2. The pushbuttons allow you to navigate the menu screens
on the LCD display. See Menu section
LCD Display
The 2 line backlit display provides status information including lifetime remaining
on lamps, message history and setup options. See Menu Section.
Pushbuttons
Left Arrow – press to move back to a previous menu and or to escape from a
menu choice.
Up Arrow – press to move up a menu in a section and also select data whether it
is menu choices or numerical values.
Down Arrow – press to move down a menu in a section and also select data
whether it is menu choices or numerical values.
Right Arrow – press to move right into a sub menu or to “Enter” a selection or
save a value.
Indicating Lights
Green Light – situated at the bottom, an illuminated green light indicates the
Upstream is treating normally. A flashing green light means the lamps are not yet
at full power or the unit is in standby mode awaiting a remote start.
